APU-102 Pentium Card Handling Procedure
Revision as of 19:52, 12 March 2025 by GMalcom (talk | contribs) (Created page with "=== Pentium Card Removal Procedure === <p><br></p> {| style="border-collapse: collapse; margin-left: auto; margin-right: auto; width: 661px;" border="1px" cellpadding="4px" |- | style="width: 57.8247px; background-color: rgb(230, 126, 35); text-align: center;" | <p>'''Caution'''</p> | style="width: 584.278px;" | <p>ALWAYS use proper ESD handling procedures when removing or installing cards in the APU-102.</p> |} <p><br></p><p>1) Disconnect cables from card</p><p>2)...")
Pentium Card Removal Procedure
Caution |
ALWAYS use proper ESD handling procedures when removing or installing cards in the APU-102. |
1) Disconnect cables from card
2) Pull on the ejector tab until you feel the card come loose from the backplane connector
 |
| Figure 1: Pull ejector tab to release card from backplane connector |
3) Grasp the card by the edges and slide it out of the card cage
 |
Figure 2 and 3: Hold card by the end or edges when sliding it out of the card cage slot |
 |
4) Any time the card is out of the card cage, DO NOT hold or carry it by the ejector tab.
- Hold or carry it by the edges ONLY.
 |
| Figure 4: Correct handling method when card is out of card cage |
Caution |
DO NOT handle the Pentium card assembly by the ejector tab. This can twist the board and cause irreparable damage, rendering the board unusable! |
ALWAYS wear an anti-static device when handling cards